That's the same with HDMI. On the board numbering starts with 0 while Linux starts with 1.1. Just want to make sure if DSI-1 corresponds to CAM0/DISP0 connector and DSI-2 corresponds to CAM1/DISP1.
Yes, numbering starts where the label is printed (J3 com CAM/DISP0 and J4 for CAM/DISP1). You can easily verify this when looking at a picture of the official FPC i.e..2. There is no pin 1 marking on the connectors. I hope pin no 1 is towards the board edge.
Bottom, what is this referring to? The connectors only have contact on one side. The lid is on the other side --> no contacts there.3. To make sure are those FPC connectors Bottom contact only?
Statistics: Posted by aBUGSworstnightmare — Tue Jul 09, 2024 9:29 am